The EN54 certified solution for voice announcement, background music and evacuation in one housing with built-in battery charger (certified to EN 54-4) and 2 pcs. 500W amplifiers. ONE has an innovative design that allows installation on a wall or in a cabinet, according to the needs of each project. It is specially designed for small and medium-sized installations and is extremely easy to install and configure thanks to the Autosetup function, which saves time and costs. The system also allows the expansion of up to 10 systems to work in a network or a total of 5000 W of power, and the two-channel operation mode allows you to make zone announcements without affecting the music in the other zones.
Technical characteristics:
- ONE has 7 audio sources:
- 3 analog audio inputs: 2 of them have a socket for ordinary microphones, and the third without to turn on background music. One input can also be used to connect a PTT (Push to talk) microphone.
- 1 mixer: the mixer can mix the sources from the 3 analog inputs as desired. So for example you can use music from one input and speech from another at the same time, in case you want the music to continue while you talk.
- BUS ACSI: To connect up to 8 MPS microphones or VAP1 fire panel to perform of evacuation messages. Microphones allow voice messages in different zones.
- 2 message players: 10 minutes memory for 2 types of messages: EVAC and ALERT.
- Speaker Lines (Outputs): ONE has 6 outputs (6 different zones) fed by 2 amplifiers. Each amplifier is 500W, but the total power connected to each ONE cannot be more than 500W. In the event of one amplifier stopping, the other will take over automatically. 2 audio signals can be played simultaneously in different zones. The lines can be monitored with an EOL end device- (LDATFL2)
- Power: the battery charger is included in the ONE and is EN54 certified. The battery allows the system to operate for 30 hours in standby mode + 30 minutes of evacuation. This includes powering the speakers for 30 minutes.
- Fire panel integration: ONE has 8 inputs and 2 outputs for integration with fire panels. Two common inputs are for starting a system-wide emergency mode and reset (end of emergency mode). The remaining 6 entrances are used to evacuate areas separately. The two outputs are for notifying the panel that the system is in an emergency or reset state. In the event that the alarm is disabled by ONE, the panel will be notified that the system is no longer in emergency mode. These links can also be monitored.
- Advanced Integrations:
- Bypassing Attenuators: This feature can be used to stop the effect of the attenuators. It will increase the volume to maximum in case of alarm.
- RS485 for Modbus communication and receiving commands from other devices.
- 4 pre-amplified outputs: in case an external amplifier must be used.
- Auto Tuning: ONE does its own tuning. No need to configure it. When the entire system is connected (including speakers and microphones), Auto Setup will detect and automatically configure: inputs, fire alarm integration, microphones and voice alarm panel, USB messages, speaker line outs, speaker line monitoring, monitoring of the battery. The possibility of human error is minimized and it takes less than a minute to configure the entire system.
- Certifications: ONE 500 is certified to the following standards (0370-CliR-3206):
- EN 54-4:1997
- EN 54-4:1997/AC:1999
- EN 54 -4:1997/A1:2002
- EN 54-4:1997/A2:2006;
- EN 54-16:2008 < /ul>
ONE500 is in stock. Contact your retailer for pricing and more product information.